| specifications︰ | Main Technical Indexes:
1.Size of rotating cage:dia-450x 600mm
2.Rotation rate of rotating cage:15rpm
3.Motor power:4x0.1kW/AC220V 50Hz
4.Wind rate of fan:55m^3/min
5.Air pressure of fan:300pa
6.Power of fan:2x0.4kW/AC380V 50Hz |
| Advantages︰ | Model HSGZ-1 Dryer is manufactured by combining the production characteristics of soft capsule production technology summarized through investigation and analysis of the actual production situations from numerous soft capsule manufacturers at home and abroad, as well as adopting the brand-new technology and materials, according to the requirements of GMP. The overall equipment is simple and practicable, artistic and elegant.
Main Characteristics:
1.Model HSGZ-1 Dryer is made of overall stainless steel material and in conformity to the requirements of GMP completely.
2.Non-lubricate structure is adopted for the rotating cage of the dryer, so that the pollution of lubricant is averted thoroughly. The whole machine can be very clean during the production process.
3.The rotating cages are in the brand-new design structure, any section of the cages can be disassembled and reassembled at will, and at the same time, the normal operation of other sections would not be affected.
4.The rotating cages are made of stainless steel plate. Its internal wall is glossy and smooth without closed angle and fin. It could avoid causing damage of capsule during cage rotation, thereby the qualification rate of capsule product can be lifted, and production cost can be lowered.
5.The cages and ventilation duct is made of stainless steel plate. Its internal wall is smooth. It can be cleaned easily and thoroughly, and cross pollution can be averted while the products of different assortment are produced.
6.Oil accepting plate is arranged inside the dryer. It could keep the floor of workshop clean and natty, and reduce waste of finished capsules.
7.The structure, which is easy to be cleaned, dismantled and reassembled, is adopted. Thus the normal maintenance can be completed without any tool. Therefore, it could shorten equipment maintenance time and lower labor intensity of operators.
|
|
|
|
